V-drive pinion nut

Heefus · Post by **Heefus** » Wed Jun 22, 2011 8:14 pm

Anyone know the size right offhand?

I am done traveling, for the week, so I reckon I will go down to the marina tomorrow and tighten her up. I would prefer to know the size before I go though, so if anyone wants to chime in....

larryeddington · Post by **larryeddington** » Thu Jun 23, 2011 10:22 am

I just checked my new starboard chrysler power pack sitting ready on pallet in my shop. Working on Port engine now.

Your answer is that pinion nut is 1 1/2 inch, I tried a wrench on it as well as measure it.

Heefus · Post by **Heefus** » Thu Jun 23, 2011 11:18 am

thanks buddy, off to NAPA!